How to execute multiple tabs?

Discussions and Tech Support specific to the iMacros Firefox add-on.
Forum rules
Before asking a question or reporting an issue:
1. Please review the list of FAQ's.
2. Use the search box (at the top of each forum page) to see if a similar problem or question has already been addressed.
3. Try searching the iMacros Wiki - it contains the complete iMacros reference as well as plenty of samples and tutorials.
4. We can respond much faster to your posts if you include the following information: CLICK HERE FOR IMPORTANT INFORMATION TO INCLUDE IN YOUR POST
Post Reply
Jonesdk
Posts: 1
Joined: Thu Jun 14, 2012 11:16 am

How to execute multiple tabs?

Post by Jonesdk » Thu Jun 14, 2012 11:24 am

Hello!

I am new to iMacros, and i am using the firefox add-on.

I have a problem, that i hope you can help me with. When i have opened, say, 8 tabs in firefox, i need to be able to execute them (like pressing "enter" would do), and i need them executed in the order 1->8, with no delay (if possible!) between them.

I have tried to record a macro using the click command (auto), but it is terribly slow i am afraid. It takes about 10 seconds the run the entire macro, because it waits for the page to load before it moves on to next page.

I only need to send the command to a server, so all 8 commands are recieved within a second or so, but the time for the page to load is not important.

I hope you can help me with my problem, and i hope i have posted in the correct sub-forum!

Cheers

Jonesdk
siniy
Posts: 118
Joined: Sat Nov 07, 2009 7:44 pm

Re: How to execute multiple tabs?

Post by siniy » Fri Jun 15, 2012 4:39 pm

Replace with your command. Set "Max:" to 8. And press "Play(Loop)"

Code: Select all

SET !TIMEOUT 1
SET !ERRORIGNORE YES
SET !LOOP 1
TAB T={{!LOOP}}
'Your command below
TAG POS=1 TYPE=TITLE ATTR=*
Post Reply