How To Start Recording From Existing Script.

Discussions and Tech Support related to website data extraction, screen scraping and data mining using iMacros.
Forum rules
Before asking a question or reporting an issue:
1. Please review the list of FAQ's.
2. Use the search box (at the top of each forum page) to see if a similar problem or question has already been addressed.
3. Try searching the iMacros Wiki - it contains the complete iMacros reference as well as plenty of samples and tutorials.
4. We can respond much faster to your posts if you include the following information: CLICK HERE FOR IMPORTANT INFORMATION TO INCLUDE IN YOUR POST
Post Reply
Posts: 1
Joined: Fri Jan 28, 2011 4:25 pm

How To Start Recording From Existing Script.

Post by FOCUSGuy » Fri Jan 28, 2011 4:30 pm


I have created a script (Fetch.imm), using the record feature.

I would like to now add to the script, starting where I left off, when I last recorded.

I can play my script (play button), and see the results in the browser panel.

However, I cannot figure out how to start to record, again, at this point in the script.

Posts: 53
Joined: Fri May 16, 2008 6:11 pm

Re: How To Start Recording From Existing Script.

Post by cboshdave » Fri Jan 28, 2011 11:32 pm

The easiest way to do that is to "Play" the existing script in the iMacros window. Then, hit record and continue. Next you can edit the #current script and copy and paste the lines and add them to your existing script.

You don't want to copy and paste all. Usually, start at Line 4. The first are usually always this:

Code: Select all

After that, your code should paste in just fine.

Good luck,
Post Reply